Arctic Power eSled CSC 2015, Operator'S Manual

Page: 60 / 116

Liite 2 (7)
7
Troubleshoot
Start the troubleshooting process by looking the symptoms from the list below.
Solve the problem with instructions provided. If the symptoms cannot be found
or the procedure cannot be committed, please contact the authorized service.
Troubleshooting guide
No table of contents entries found.
The snowmobile does not react to the key
1. Faulty battery or broken fuse
If the snowmobile reacts to the charging cable, check main fuses F1.1
and F2.1 and 12V system battery. Replace if faulty. Please refer to page
17.
Unidentified fault
Contact manufacturer
Plugging the charge connector does not initiate the charging
1. Power pack poorly attached
Check the connectors in power pack. For instructions please refer to
page 13.
2. Fault in wall socket or charging station
Check the wall socket or charging station for faults
3. Faulty charger
Contact manufacturer
Stays at ”Changing mode” while starting up
1. Traction system master switch
Make sure that the Traction system master switch is turned to ”ON”
position. The switch can be found from the rear end of the power pack.
Turn the key clockwise to turn it on.
2. Faulty controller
Contact manufacturer
”Changing mode” stays while cranking but returns to default screen.
1. Kill switch in ”OFF” position or tether removed.
Pull kill switch to position ”ON” or connect tether
2. Insulation monitoring device detects an error and GFD-led is lit.
Contact manufacturer