Arctic Cat Sno Pro 120 2011, Service Manual

Page: 340 / 535

6-17
6
0742-020
17. Slide the driven pulley onto the input shaft making
sure alignment washers are in place (if applicable).
18. Secure the driven pulley with components and hard-
ware as noted in removing. Tighten to 32 ft-lb.
ZJ250A
19. Install the drive belt.

NOTE: For installing drive belt, see Drive Belt in this
section.
20. Check the track for alignment and recommended ten-
sion; then tighten the cap screws securely (see Track
Tension and Track Alignment in this section).
21. Install and secure the side panels.
DISASSEMBLING GEAR CASE
(w/Reverse)
1. On electronic reverse models, remove the three torx-
head cap screws securing the shift actuator to the
gear case and remove the actuator; then remove the
gear indicator switch.
ZJ186A
2. Remove the torx-head cap screws securing the gear
case cover to the gear case assembly; then insert two
flat-blade screwdrivers into the slots on the gear
case. Working back and forth, pry the cover up and
off the gear case. Discard the gasket.
742-195C
742-196C
3. Drain the gear case fluid into a suitable container.
4. Remove the shift fork assembly; then remove the
retaining ring securing the shift fork arm to the shaft
and remove the arm. Account for the retaining rings,
O-ring, and slider blocks.
ZJ300

NOTE: For assembling purposes, note the position
of the slider blocks on the shift fork arm.
CAUTION
If the input shaft bearing is removed, always replace it
with a new one or severe component damage may
occur.
Manual
Table of Contents