Arctic Cat S2009BCDFCOSL, Operator'S Manual

Page: 16 / 88

12 GENERAL INFORMATION
At this point, the hours display will
begin to flash. Push the increment but-
ton to increase the hours; push the dec-
rement button to decrease the hours.
Pushing and holding a button will
accelerate the number display. When
desired hour number is displayed, push
the select button.
At this point, the minutes display will
begin to flash. Push the increment but-
ton to increase the minutes; push the
decrement button to decrease the min-
utes. Pushing and holding a button will
accelerate the number display. When
desired minute number is displayed,
push the select button.

NOTE: During clock setting if no
button (increment, decrement,
select) is pushed within a 5-sec-
ond time period, the clock-setting
mode will be exited with changes
saved.
The altimeter readout is based off baro-
metric pressure and may require cali-
bration as weather conditions change.
To calibrate the altimeter to an estab-
lished altitude with altimeter selected
on the display screen by pushing and
holding the select button for a mini-
mum of two seconds, the acronym
CAL will be displayed on the readout
screen for one second; then the altitude
value will flash. Push the increment
button to increase the displayed alti-
tude; push the decrement button to
decrease the displayed altitude. Push-
ing and holding a button will accelerate
the number display.

NOTE: If MPH has been selected
in the speed readout, the altitude
value will be displayed in feet. If
kph has been selected in the
speed readout, the altitude value
will be displayed in meters.
To reset the maximum altimeter read-
out with the maximum altimeter dis-
played, push and hold the select button
for a minimum of two seconds.
Service Icon
On electric start models, the icon
should illuminate each time the key is
turned to RUN or START, and it should
go out when the engine starts. If the
icon stays illuminated (on electric start
models) or it illuminates while the
engine is running, the system is receiv-
ing input that is outside of its estab-
lished parameters. If the system icon
illuminates indicating an error, take the
snowmobile to an authorized Arctic
Cat Snowmobile dealer for service. If
not under warranty, this service is at the
discretion and expense of the snowmo-
bile owner.
Coolant Temperature
Warning Icon
If the coolant temperature is at or
above the maximum running tempera-
ture, the coolant temperature warning
icon will flash a warning (alert). If the
coolant temperature is at or above the
maximum running temperature, the
coolant temperature warning icon will
cease flashing and will remain con-
stantly illuminated.
Crossfire/F-Series/M-Series/T500
Steady Flash
(Coolant
Temperature Icon) Coolant Tempera-
ture Above 80° C
(176° F).
Constant On
(Coolant
Temperature Icon) Coolant Tempera-
ture Above 93° C
(200° F).
Z1/TZ1
Steady Flash
(Coolant
Temperature Icon) Coolant Tempera-
ture Above 110° C
(230° F).
Constant On
(Coolant
Temperature Icon) Coolant Tempera-
ture Above 115° C
(239° F).