19
KM262
2. Install the centrifugal clutch housing onto the driven
shaft; then install the splined bushing and secure
with the driven pulley retaining nut. Tighten to 40 ft-
lb.
KM276
3. Install the movable drive face onto the crankshaft
making sure to “bottom” the sheave out against the
center bushing. The crankshaft splines should be vis-
ible and the stepped washer should sit over the
splines.
KM263A
4. Secure the movable drive face to the crankshaft with
the drive pulley nut and tighten to 72 ft-lb.
5. Install the V-belt cover and tighten the cap screws
securely; then connect the cooling boots and tighten
the clamps securely.
KM252A
6. Install the recoil starter and footwell assembly (Util-
ity). Tighten all hardware securely.
CAUTION
If the splines are not protruding as shown, the V-belt
may be too deep in the drive sheaves. This would cause
the drive pulley to be under-tightened and severe drive
sheave or crankshaft damage could occur.
CAUTION
On the DVX, the rear boot clamp must be oriented as
shown or interference with heat shielding could occur.
