Arctic Cat 2012 700 i Cruiser, Operator'S Manual

Page: 173 / 708

41
Division
II - Operation
/
Ma
in
te
na
n
ce
Previous Main Table of Contents Section Table of Contents Next Previous Main Table of Contents Section Table of Contents Next
3. Mode Button - Shifts the gauge through three set-up modes: speed-
ometer/tachometer, distance, and time.

NOTE: The Mode Button must be pressed and released to
shift modes. Approximately two seconds after the Mode
Button is released, the digital gauge will return to full dis-
play.
4. Set/Reset Button - In conjunction with the Mode Button, sets and
resets various displays on the digital gauge. Also used to shift from
speedometer function to tachometer function on the speedometer/
tachometer gauge.
5. Fuel Level Indicator - Indicates approximate amount of gasoline in
the gas tank.

NOTE: When the bottom segment flashes, approximately
3.5 L (0.92 U.S. gal.) of gasoline remains in the tank.
6. Low Oil Pressure - Will be displayed during self-test at start-up. It
will not be displayed during normal operation as oil pressure is not
monitored on these models.
7. Odometer/Trip Meter - Odometer registers the total distance the
vehicle has traveled. The trip meter is resetable and can be used to
measure trip or trip legs. The odometer cannot be reset.

NOTE: To shift between the odometer (ODO) or trip meter
(TRIP), press the Mode Button (3) to select the distance
mode; then press the Set/Reset Button (4) to select the
desired display. Hold the Set/Reset Button down to reset the
trip meter.
8. Gear Position Indicator - Indicates which gear position is selected.
• R (reverse)/N (neutral)/L (low range)/H (high range)

NOTE: An E will be displayed if there is an error caused by
a no-shift position signal.
9. High Beam Indicator - The High Beam icon will appear only when
the headlights are on high beam.
10. Drive Select Indicator - Displays 4WD when selected by the drive
select switch. The display is blank when in 2WD.
11. Speedometer - Indicates the approximate vehicle speed in miles
per hour (MPH) or kilometers per hour (km/h).

NOTE: To change mph/km/h display, press and release
Mode Button (3) until the icon (MPH/km/h) appears; then
press the Set Button (4) to change the display.
Condition Warning Display - Uses odometer/trip meter display of the
LCD to warn of a system error condition requiring attention.
A. Volt - The LCD will go blank except the word VOLT will flash
on the LCD whenever a low voltage (< 9 DC volts) or a high
voltage (> 16 DC volts) is detected. When voltage returns to
normal, the gauge must be reset by turning the ignition key to
the OFF position and then to the ON position.
B. EFI - The LCD will go blank except a diagnostic trouble code
(DTC) will flash on the LCD and a wrench icon will be displayed
whenever an electronic fuel injection malfunction is detected.
After 30 seconds, the LCD will return to normal; however, the
DTC and wrench icon will continue to be displayed until the mal-
function is corrected.

NOTE: Take the ATV to an authorized Arctic Cat ATV
dealer to have the EFI error corrected and to have the ECU
reset as soon as possible.
Gas Hoses
Replace the gas hose every two years. Damage from aging may not
always be visible.
Electric Fuel Pump
An electric fuel pump is incorporated in the gas tank to deliver gaso-
line to the fuel injector. The fuel pump is activated when the ignition
switch is in the ON position.
2012 XC 450 i