85
6. Install the locating ring in the crankcase assembly;
then install the secondary driven shaft assembly and
secondary drive assembly making sure the locating
ring and bearing engage correctly.
GZ269A
GZ448A
7. Make sure the locating pins on the front and rear bear-
ings are correctly seated in the crankcase.
8. Install two alignment pins into the upper crankcase
assembly; then apply a thin bead of silicone sealant to
the lower crankcase cover.
GZ452A
GZ451
9. Carefully place the lower crankcase cover onto the joined
crankcase halves; then secure with the cap screws.
Tighten the 6 mm cap screws to 8 ft-lb and the 8 mm cap
screws to 20 ft-lb.
GZ447
10. Install the oil screen; then apply a thin bead of silicone
sealant to the oil strainer cap and secure with the cap
screws. Tighten to 8 ft-lb.
Installing
Engine/Transmission
NOTE: Arctic Cat recommends that new gaskets
and O-rings be installed whenever servicing the ATV.
1. Turn the front driveline to place the output drive
yoke universal joint in the horizontal plane; then
secure the driveshaft to the right and against the
engine.
AT THIS POINT
After completing center crankcase components, proceed to
Installing Right-Side Components, to Installing Left-Side
Components, and to Installing Top-Side Components.
