4-6
CH015D
INSTALLING
1. Connect the gas and vent hoses onto the carburetor.
2. Connect the electric choke lead to the wiring har-
ness.
CC740A
3. Place the throttle cable into position and secure by
tightening the outer jam nut.
PR162B
4. Connect the throttle cable to the actuator arm.
PR162C
5. Place the throttle actuator cover into position on the
carburetor; then secure with the screw.
PR154B
6. Position the carburetor in the air cleaner boot and
intake pipe assembly; then secure with the clamps.
7. Connect the hose from the carburetor to the gas tank.
8. As necessary, secure the air-intake snorkel, the air
filter housing cover, or the air filter housing.
9. Install the seat.
Electric Choke
REMOVING
1. Disconnect the electric choke connector from the
wiring harness; then remove the screw securing the
choke body to the carburetor.
2. Carefully remove the choke assembly from the car-
buretor taking care not to force the plunger from the
carburetor body.
INSPECTING/TESTING
1. Inspect the plunger (A) for scoring or scratches, the
needle (B) for damage to the tip, the spring (C) for
breakage, and the O-ring (D) for breaks.
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
