Arch Environmental Equipment, Inc.
SABER
MAX
BELT CLEANER
INSTALLATION INSTRUCTIONS
THE INSTALLATION OF THE SABER
MAX
BELT CLEANER IS VERY SIMPLE.
IT REQUIRES ONLY A FEW TOOLS AND LITTLE TIME.
THE TOOLS & RESOURCES REQUIRED ARE:
1. STRAIGHT EDGE
5. WELDING EQUIPMENT
2. LEVEL
6. CHALK
3. TAPE MEASURE
7. ADJUSTABLE WRENCH
4. CUTTING TORCH
8. STRING (36" or more)
SHUT DOWN AND LOCKOUT CONVEYOR BEFORE
PERFORMING ANY MAINTENANCE
STEP 1
Determine the diameter of the head pulley and the thickness of the conveyor belt.
Example: head pulley diameter = 36"(914.4mm), belt thickness = 1 ¾”
(44.45mm).
Take one half of the head pulley measurement (in this case 18"(457.2mm)) and
add the belt thickness. This will give an effective radius of 19 ¾” (501.65mm). If
the pulley is smaller than 22” diameter, you cannot use the Saber MAX on this
application.
STEP 2
To this number add dimension "A" ( 4 1/4" (107.95mm)). This will give you the "Z"
dimension. See fig. 1. To assist in achieving this spacing, urethane installation
rings have been provided with the cleaner. Use them as directed in step 7.
