28
7
ASSEMBLY/DISASSEMBLY OF CONTROL CARD
7.1
Removing Card Box
Main board is on the upper wall of the refrigerator. Card cover is fixed to the card box with 4
tabs and one screw. Screw is loosened with the help of Phillips screwdriver. Afterwards, the cover is
pulled from the tabs by sliding to the section where screw is connected, card box cover is removed.
The same procedure is repeated reversely for mounting again.
7.2
Removing the Main Card
Sockets found on the main card are pulled and removed. They are attached to the card box
with the help of snap-fits. Snap-fits are stretched by a flat and pointed tool, and the card is pulled.
8
DISASSEMBLY OF HINGES
8.1
Removing the Upper Hinge
To remove the upper hinge part, first the body hand plate must be removed. The body hand
plate is attached on the product by means of 2 screws. After removing the screws with Phillips
screwdriver, the body hand plate is detached and thus the upper hinge part becomes accessible. The
upper hinge part is attached by means of 2 screws. Screws are removed with a Torx screwdriver, and
upper hinge part is mounted easily.
