36’’ 3 DOORS WARDROBE TYPE REFRIGERATOR
/ REV
NO: 00
13
3. INSTALLATION
3.1.Handling Instructions
1. This appliance must be transported only in upright position. Shipping package must not be
damaged during transportation.
2. If the appliance is to be transported in horizontal position, it must only be leaned towards
right-hand side when you are facing the front of the appliance. After bringing it to upright position, it
must be left for at least 4 hours without being operated in order to have it settled.
3. Failure to obey above instructions may result in damage on the appliance. In case of failure
to obey these instructions, the manufacturer shall not be held responsible.
4. The appliance must be protected against rain, humidity and other atmospheric effects.
5. Pay attention not to damage your floor, the pipes, wall coverings and etc., while installing
your appliance. The appliance must not be handled by pulling from the door or door handle.
6. Discharge the water in the drain tray before moving the appliance. For detailed information,
see “Cleaning and Maintenance” section in the operation manual.
7. Do not sit on or climb to the appliance since the design of the appliance is not suitable for
such actions. You may injure yourself or damage the appliance.
IMPORTANT!
To prevent cutting or damaging the power cable, make sure that the cable is not
pinched under the appliance during and after moving it.
3.2 Installation Instructions
1. Volume of the room where the product will be installed must not be less than 10 cubic
meters.
2. Do not place the appliance in a cold room where the temperature is likely to fall below 10°C
at nights and/or especially in winter season.
This refrigerator/deep freezer is designed to operate in ambient temperatures between 10°C
and +43°C.
3. Do not place the appliance near ovens or radiators or under direct sunlight since they will
cause the appliance to operate more difficultly. In case of placing the appliance near a heat source or
freezer, ensure that the following minimum clearances are provided.
From ovens: 50 mm (2")
From radiators: 400 mm (12")
From freezers: 25 mm (1")
From the wall: 50 mm (2")
4. Mount the 2 plastic wedges supplied in a bag in the refrigerator onto the rear ventilation
cover as illustrated in the following figure. To do this, remove the screws on it and attach the screws
given in the same pouch. Plastic wedges are for the required distance between your refrigerator and
the wall in order to allow the air circulation.
Summary of Contents for BEKO G91629NWU
