arcelik BEKO COSMOS, Service Handbook, Page: 17 / 274

SBS COSMOS REFRIGERATOR
07.11.2018 / REV NO: 01
17
Sensitivity: Public
5. INSTALLATION
5.1. Handling Instructions
1. This appliance should be transported only in upright position. Delivery package should not
be damaged during transportation.
2. If the appliance is to be transported in horizontal position, it should only be leaned towards
right-hand side when you are facing the front of the appliance. After bringing it to upright
position, it should be left for at least 4 hours without being operated in order to have it settled.
3. Failure to obey above instructions may result in damage on the appliance. In case of
failure to obey these instructions, producer shall not be held responsible.
4. The appliance must be protected against rain, humidity and other atmospheric effects.
5. Pay attention not to damage your floor, the pipes, wall coverings and etc., when installing
your appliance. The appliance should not be carried by pulling by the door or door handle.
6. Discharge the water in the drain tray before moving the appliance. For detailed
information, see “Cleaning and Maintenance” section in the operation manual.
Do not sit on or climb to the appliance since the design of the appliance is not suitable for
such actions.
You may injure yourself or damage the appliance.
IMPORTANT!
To prevent cutting or damaging the power cable, make sure that the cable
is not pinched under the appliance during and after moving it.
5.2.
Handling Instructions
1. Volume of the room where the product will be installed should not be less than 10 cubic
meters.
2. Do not install the appliance in a cold room where the temperature may fall below 10°C at
nights and/or especially in winter season.
This refrigerator/deep freezer has been designed to operate in ambient temperatures
between 10°C and +43°C. For this reason, in case of installing the appliance in a cold place
without heating facility (e.g. garage outside the house), it will not operate and the freezer
compartment will get warmer which will end up with decreased preserving times for frozen
foods.
3. Do not install the appliance near ovens or radiators or under direct sunlight since they will
cause the appliance operate more difficultly. In case of placing the appliance near a heat
source or freezer, make sure that the following minimum clearances are provided.
From ovens: 50 mm (2")
From radiators: 400 mm (12")
From freezers: 25 mm (1")
From the wall: 50 mm (2")
4. Insert the 2 plastic wedges supplied in a pouch in the refrigerator onto the rear ventilation
cover as illustrated in the following figure. To do this, remove the screws on it and attach the
screws given in the same pouch. Plastic wedges will provide the required distance between
your refrigerator and the wall in order to allow the air circulation.