arcelik Beko B13, Service Handbook

Page: 35 / 111

B13 B7S B7SLED WASHING MACHINE SERVICE HAND BOOK
35
Use only a soft and damp cloth to clean the control panel.
6.4. Cleaning the water inlet filters
There is a filter at the end of each water intake valve at the rear of the machine and
also at the end of each water intake hose where they are connected to the tap.
These filters prevent the foreign substances and dirt in the supply water to enter into
the machine. Filters should be cleaned when they become dirty.
Figure 6.3
1. Shut the taps.
2. Remove the nuts of the water inlet hoses and clean the sediments on the filters of
the water inlet valves with an appropriate brush. If the filters are too dirty, remove
them from their places with a pliers and clean in this way.
3. Remove the filters on the flat end of the water inlet hoses along with their seals
and wash them under running water well.
4. Replace the seals and filters carefully and tighten their nuts by hand.
6.5. Draining the remaining water and cleaning the pump filter
The filter system in your machine prevents solid items such as buttons, coins and
fabric fibers clogging the pump impeller during discharge of washing water. Therefore
the waste water is discharged without any problems and the service life of the pump
is increased.
If the machine does not drain the water, pump filter may have been clogged. Filter
should be cleaned when clogged or once in 3 months. In order to clean the pump
filter, first the water should be drained.
Also, before transporting the machine (for example when moving to new house) and
when the water has the risk of freezing, water may have to be fully drained.
WARNING: Foreign objects which stay inside the pump filter may damage your
machine or cause noise problem.
WARNING:
If the product is not being used, tap should be shut, mains pipe should be
removed and the water inside the machine should be emptied against any likely
freezing.
WARNING: Shut the tap which the mains pipe of the product is connected to after
each use.