Ohm Loads
This amplifier operates in the traditional sense with regard to Ohm loads. Lowering the Ohm load will increase power
output however it will also increase current draw and produce more heat. This amplifier is capable of running any mix or
combination of Ohm load on the front and rear channels. They do not have to be the same.
Any speaker or combination of speakers with a total combine Ohm load between 2 and 4 Ohms can be used on any single
channel.
Bridged loads
must not drop below 4 ohms
but my exceed 8 Ohms if needed. This will not damage the amplifier however
power output will decrease at higher load.
WARNING: This amplifier will not operate and could be
damaged if used in the wrong configuration. At no time
can it be operated below 2 Ohms stereo or 4 Ohms
bridged.
Speaker outputs
This amplifier is a multi channel amplifier design. Meaning it has more than one channel of speaker outputs. It is
equipped with a removable plug style terminal for speaker wire connections up to 14 AWG. Make this connection
carefully and neatly. Strip your wire back 5/16” and twist the exposed leads and insert them into the block terminal while
being careful that there is no loose or frayed strands of wire.
Tighten the standard head screw down on the terminal until
the wire is tightly secured in place. If the wires ever come in
contact with each other the amplifier will go into protection.
Know your total ohm load before you make any connec-
tions.
5
/
16“
8MM
Strip Speaker Wire
Bass Boost
This amp has an adjustable bass boost. The frequency is fixed at 45Hz. The level of the boost can be adjusted up
to 12dB. Start with a small increase in the level control. then “sweep” the frequency up and down. Listen carefully
for an improvement in the sound of the bass. If you do
not hear any improvement then the woofer does not
need any boost.
WARNING:
Use Bass Boost carefully. The demands on
power output are tremendous. Try to minimize the use
by changing woofer position or the enclosure size.
4
