98
Serial Communication and Commands
Set Output Frequency
Command:
mPF
mPF sets the programmable pulse output frequency for Programmable Pulse B from 1 to 1000
pulses per second, where m = the frequency in pulses per second. Used with the Frequency Mode.
Response:
C
Set Time Selection
Command:
m,nPS
m,nPS sets the programmable pulse time selection to either UTC or Local, where m = 0 for UTC
and m = 1 for Local, and n = 0 for Programmable Pulse A and n = 1 for Programmable Pulse B.
Response:
C
10.3.13
Antenna System Delay Commands
Set Antenna Delay
Command:
nnnnnnDA
Sets antenna system delay compensation value. NOTE: Factory default setting for the standard
15-meter (50-foot) cable is 60 ns. Time range is from 0 to 999999 nanoseconds. The exact syntax
for a 60-ns delay is 60DA. See Section 4.4.1 for information on calculating cable delay.
Response:
C
10.3.14
Out-of-Lock Commands
Set Out-of-Lock Time
Command:
(-)nLK
(-)nLK configures the Out-Of-Lock function in the 1094B. A negative number turns the out-of-lock
function OFF. n = 0 sets the out-of-lock time to zero delay. n = 1 to 99 sets the amount of delay
time (in minutes) following loss of satellite synchronization before an out-of-lock signal is generated
and the relay contacts close.
Response:
C
10.3.15
Miscellaneous Commands
Return Firmware Version
Command:
VE
Returns the Firmware Revision date of the installed ROM.
Response: dd mmm yyyy
C
