10
English
PROFILE-V
To replace, position the shield on the base plate so that the lower part of
the sliding slot of the shield is over the spring clip of the base plate and
the brass stud is in the red hole of the base plate
⑦
. Press the shield
onto the spring clip, and then fully raise the shield until the brass stud falls
into the sliding slot of the base plate
⑧& ⑨
. Position top hook on the
backside of the side pod into the top tab of base plate
⑩
, align the side
pod with the recess of the helmet shell and push the lower part of the side
pod down firmly until it clicks into place and is fully captured by the base
plate
⑪
. Repeat for the other side. Work the shield up and down to
confirm proper operation
⑫.
.
TO REMOVE/REPLACE BASE PLATE
To remove, first remove the shield. Remove two screws from each base plate
with a flat blade screwdriver or a coin
①
. Remove plates from helmet shell.
Note the right and left base plate for proper reinstallation.
To replace, place base plate over the threaded screw receptacles in the
helmet. Install the two screws through each base plate into the helmet finger
tight
②
, do not fully tighten. Install shield, lower the shield to fully closed
position and press the front center of the shield to bring it against the eyeport
trim. While still pushing on the shield to keep a tight seal against the eyeport
trim, tighten the base plate screws
③
– but be careful not to overtighten,
as the screws may break. It may be necessary to do one side at a time, with
a smoothing pressure from the shield center toward each base plate and
tightening one and then the other for best results.
⑨
⑦
⑧
⑫
⑪
⑩
①
②
③
