7
3+ mm
Finishing Lid:
PREFERRED - Fill gap surrounding
inlay material using an appropriate
expansion joint gap filler (A).
ALTERNATE - Apply grout around
inlay perimeter using preferred
mortar/grout compound (B)*.
DO NOT USE HARSH CHEMICALS,
ACID WASHES OR ABRASIVE
MATERIALS TO CLEAN LID
* Using rigid grout or mortar may result in gaps/cracking appearing over time due to natural expansion & contraction.
To position inlay material:
Carefully flip Lid over and check inlay is
centred for consistent grout line
thickness.
If required insert tiling wedges or
similar to adjust inlay to correct
position (A).
LEAVE FOR APPROXIMATELY 24
HOURS TO ALLOW ADHESIVE TO
CURE FULLY.
To install inlay material into Lid:
Place inlay material face-down on a
flat work surface.
Invert Lid and lower onto inlay material
(A) until Lid outer rim is touching work
surface (B).
LEAVE FOR APPROXIMATELY 15
MINUTES TO ALLOW ADHESIVE TO
PARTIALLY CURE.
FOR INLAYS MORE THAN 3 mm
THINNER THAN INTERNAL LID DEPTH
To apply adhesive :
Insert V-LOCK Adhesive into caulking
gun & cut nozzle to provide a
minimum 6mm wide bead.
Apply a generous, even bead across
entire internal surface of Lid (A).
Insert Spacer Plate into Lid (B).
Apply generous, even bead across
entire top surface of Spacer Plate (C).
4B
5
6
7
•
•
•
•
•
•
•
•
•
•
