4.2.
Installation site requirements
Caution 1: The floor must be able to support the expected load.
Caution 2: A suitable drainage system must be provided for water that could overflow.
Important:
Due to the combined weight of the spa, water and users, it is very important that the base
the spa is installed on is even, flat, level and able to evenly support that weight throughout the entire
period. which spa is installed. If the spa is placed on a surface that does not meet these requirements,
any damage caused by improper support will void the manufacturer's warranty. The spa owner must
ensure the integrity of the site at all times.
4.2.1.
Indoor Installation
Be aware that there are specific requirements if you are installing the spa indoors:
●
The floor must be able to support the capacity of the spa. The floor should be a non-slip, level
surface.
●
For the installation of the spa indoor, it is essential to provide suitable drainage. If you are
installing a new room for the spa, it is recommended that you install a floor drain.
●
Moisture is a natural side effect of installing a spa. Determine the effects of humid air on exposed
wood, paper, etc., where you plan to install the spa. To limit these effects, it is better to provide
good ventilation in the selected area. An architect can help you determine if more ventilation is
needed.
Note:
Do not install the spa on a carpet or any other material that can be damaged by moisture.
4.2.2.
Outdoor Installation
Regardless of where you are installing the spa, it is important to have a solid support foundation:
●
If you are installing the spa outdoor, make sure there are no sharp objects present that could
damage the spa. Then, the area needs to be level, so that the spa can be placed in a stable and
proper position.
●
While filling, draining, or using, water may overflow from the spa.
●
Do not leave the spa surface exposed to direct sunlight for extended periods of time.
10