AquaPur 60519, Operating Instructions Manual

Page: 38 / 53

- 35 -
GB
MT
Usage
NOTE
► This lint remover can damage structured fabrics or very
soft materials such as angora. Therefore, always test the
lint remover on an inconspicuous part of the garment and
turn the transparent part of the spacer
1
fi rst to the level
"Thick" and then set the speed to level I. In this way you can
gently test whether the setting is suffi cient for the garment
without damaging it.
► This appliance should not be brought into contact with
moisture. Therefore, do not use the lint remover on moist
fabrics.
1) Lay the garment on a fl at surface, such as an ironing board.
Ensure that the surface to be processed has no wrinkles.
Otherwise, the garment could be damaged.
2) Turn the spacer
1
to the desired position or remove it com-
pletely (see Chapter "Removing/replacing the spacer"):
–
"Thick" for large bobbles and coarse textiles (large
distance to the cutter knives)
–
"Thin" for small lint/bobbles and fi ne textiles (small
distance to the cutter knives)
–
Remove the spacer, only for very fi ne lint (virtually no
spacing to the cutter knives).
3) Using the On/Off switch/Speed switch
5
, switch the lint
remover to the speed level I.
4) Guide the shaver foil
2
lightly and without pressure over
the garment. The fl uff and bobbles will be shaved off and
collected in the fl uff collector
3
.
5) If you are feeling confi dent and the results are satisfactory,
you may want to place the On/Off switch/Speed switch
5
to speed level II so you can work faster.
IB_60519_AFR3A1_LB5.indb 35 IB_60519_AFR3A1_LB5.indb 35 16.07.14 16:36 16.07.14 16:36