Aquacal AutoPilot SP05, Installation Manual

Page: 80 / 89

Page - 76
3.4 Heating Recommendations
The following recommendations will reduce the amount of time required to heat a pool.
If unsure of
equipment heating capability, review equipment data plate. See " Identifying Model Specifications " on
page 74.
1. Confirm heat pump mode has been set to heating mode.
2. Set the desired temperature (set-point) for the water.
3. Temporarily set the filter pump for continuous operation.
l
This will allow the Heat Pump the time required to heat the water at start-up.
l
After the water has reached the desired temperature, reset the filter pump to normal operating time-frames.
4. Use a pool cover or blanket to reduce heating time.
3.5 Cooling Recommendations
The following recommendations will reduce the amount of time required to cool a pool or cold plunge
application.
If unsure of equipment cooling capability, review equipment data plate. See " Identifying
Model Specifications " on page 74.
1. Confirm heat pump mode has been set to cooling mode.
2. Set thermostat to desired water temperature.
3. Temporarily set the filter pump for continuous operation.
l
This will allow the Heat Pump the time required to cool the water at start-up.
l
After the water has reached the desired temperature, reset the filter pump to normal operating time-frames.
3.6 Available Accessories
Accessories may be purchased through an authorized dealer of AquaCal
®
products.
Bypass Valve Kit (# STK0135)
l
When high flow rates are outside recommended
specifications, please use this kit or an alternative bypass
valve system.
l
This kit can be used to control excessive water flow
through the heat pump. It provides automatic flow
adjustments for most applications.
Call Flex Accessory (# 0030-LEDS)
l
This accessory will override a circulation pump to provide
water to the heat pump when the set temperature is not met.
3
-
A
ppe
ndi
x