GRIPLOCK™ CYLINDER BAND
Installation of GripLock™ Cylinder Band
1
Remove the bail from the cylinder band. Insert the open end of the
cylinder band through the left slot in the BC, weave it through and out
the right BC slot
(Fig. 1 & 2)
.
READ ALL INSTRUCTIONS PRIOR TO ASSEMBLY
NOTE:
Before removing the original cylinder band, examine how it is woven through the
BC. It is critical to weave the GripLock™ cylinder band in the same fashion.
Figure 2
Figure 1
428230 - Wrapture Version
428210 - Non-Wrapture Version
3
Push the lever forward until it stops in the
pre-locked position
(this
keeps you fingers from being caught in lever)
(Fig. 10)
.
Push the lever
down into the
locked position
. Verify the lever is secured in the
locked
position
(Fig. 11)
. Once the cylinder band is set up, further adjustment is
typically not needed.
4
Check the cylinder band is secure by pulling on the band while holding
down the cylinder at the valve. If the cylinder band moves, it is too loose.
Check the macro adjustment is set for the correct size cylinder. Repeat steps
1-4 of
Securing the GripLock™ Cylinder Band
to tighten and secure the
cylinder band.
Rev. 11/12
If you have any questions regarding the GripLock™ cylinder band or the
information found in this manual, please contact your regional Aqua Lung
Dealer or Distributor. Distributor information is available on the Aqua Lung
website at:
Figure 11
Figure 10
GripLock™ Components
MICRO
ADJUSTMENT
BAIL
LEVER
BAIL
SLOT
MACRO
ADJUSTMENT
Threading the GripLock™ Cylinder Band
WARNING:
Verify the tension of the cylinder band prior to every dive. Failure to do
so may result in the cylinder tension slipping during the course of a dive.
