10
Quality for Professionals
5.6 Fastening the control module
Fasten the mount (supplied as standard)
into the cabin with two screws.
30 A fuse
12-pin plug connector
3-pin plug connector
6-pin plug connector
ATTENTION: If possible, do not roll the cable into a coil!
A 3-pin plug (= connection to the continuous positive), a 6-pin plug (= connection of
seed drill to control module) and a 12-pin plug for the sensors are attached to the
underside of the control module. Ground wheel or cable for 7-pin standard socket,
etc.).
On request, these are available as an accessory to the PS 120/200/300/500M1 and
PS 500 M2 seed drill!
There is 30A fuse on the right side of the control module.
TIP: Take the angle at which you view the module into account so that you are sure
to be able to read off from the display optimally. You might have to bend the mount
slightly to set the correct angle.
Pic.: 11
