36
Calibration button input
Information on the speed sensors:
Current forward speed.
If "N/A" is displayed, the selected speed signal is not available.
If a wheel, radar or GPS sensor input is used to determine the forward speed, this point
is coloured green.
Measured voltage and the currents:
Here, the supply voltage measured on the Control Box and the
minimum supply voltage since the start are displayed.
Here, the current of the seeding shaft motor measured by the
Control Box is displayed. For the PS TWIN implement type, two
displays are shown here.
7
SPECIAL FEATURES OF THE PS-TWIN
If a PS-TWIN is configured, it is possible to either spread one seed type with two sections beside each
other or spread two seed types with the same working width behind each other.
This is set in the Basic settings menu with the "Number of seed types to be spread" display element (see
Point 5.2).
7.1
SPREADING OF TWO SEED TYPES
If "2" is selected for the "Number of seed types to be spread" display element in the Basic settings menu,
two seed types can be configured in the Work menu.
It must be ensured that the same working width is entered for both seed types. If this is not the case, the
message "Working widths inconsistent!" will be shown.
If the settings are still not changed, the larger entered working width will be automatically adopted for both
seed types and used for spreading the seed. If the difference is large, it can cause the metering unit to
operate outside of the normal operating range!
7.1.1
WORK MENU
The Work menu is already described under Point 6.2. For the PS TWIN implement type, this menu was
extended. Under this point, only the changed or new buttons and their functions are described.
Summary of Contents for ISOBUS M2
Page 54: ...54 NOTES ...
Page 55: ...55 NOTES ...
