23
Control Unit
CU4 AS-interface
Operating Manual: UK-0
Control Unit CU4 AS-interface UK-0 / 31.05.2010
UK
8.1.
Turning actuator, e.g. for butterfly valves
Caution!
The permanent magnet is made of fragile material and must be
protected against mechanical load . – Risk of fracture!
The magnetic fields can damage or delete data carrier or
influence electronic and mechanic components.
Assembly of the Control Unit on the valve
1.
Assembly of the adapter on the turning actuator.
Fasten with 3 screws.
See to the right positioning of the o-rings on the lower side
of the adapter and in the groove of the air transfer stud.
2.
Install operating cam with shaft rod prolongation.
Secure with Loctite semi-solid and fasten it.
3.
Place the control unit via the operating cam onto the adapter.
Observe alignment.
4.
Attach the clamp rings and fasten them with the screws.
8.
CU Assembly and Start-up
!
operating cam with
permanent magnet
CU cover
CU base with electronic
module, sensor tower and
solenoid valves
clamp ring
fastening screws
adapter
turning actuator
