APsystems ECU-3 V4 Installation/User Manual
14
Basic Operation
Figure 18
Status:
Report both the number of inverters that
should be connected to the ECU (Total), and
the number that are actually connected
(Connected). These numbers should match.
Figure 19
Turn off all:
Turn off all the entire system. Choose “Ok”,
and the system of inverter will be turned off.
Choose “Cancel”, ECU will exit the menu.
Figure 20
If within one minute without pressing the button again, then
automatically exit the menu button.
NOTE:
The above operation should be done under the
guidance of technicist.
Restore the factory set operation
The following diagram guides to the connectors back of APsystems
ECU.
Figure 21
RESET
For the ECU restoring the factory set, simply press the “Reset”
button for three seconds or longer, ECU will automatically
return to the default settings.
Connected:
12
Total:
15
Ok
Cancel
Level:
[= = = = =]
