Release 00
2003-02
53
Scarabeo 50 I.E.-50/100 4T
1
2
Never apply the rear brake lever after removing the
brake caliper. To do so will cause the caliper pistons
to fall out of their seats in the caliper. This will cause
brake fluid to spill from the caliper.
♦
Remove the brake caliper (2), by carefully withdrawing
it from the brake disc.
REASSEMBLY
Keep your fingers clear, do not allow them to be-
come crushed between the wheel, the caliper or the
fork. Do not attempt to align the holes in the caliper
using your fingers. Use work-gloves to carrying out
these operations. Failure to obey this warning can
cause serious injury.
♦
Insert the brake caliper (2) on the disc and position it
so that its fastening holes and the holes on the support
are aligned.
When reassembling the brake caliper, replace the
caliper screws (1) with two new screws of the same
type.
♦
Tighten the two screws (1) to the appropriate torque.
Brake caliper screws (1) tightening torque:
27 Nm (19.53 ftlb).
After reassembly, pull the rear brake lever repeatedly
and check the correct functioning of the braking
system.
CAUTION
WARNING
WARNING
WARNING
REMOVING THE REAR BRAKE SHOES
100
Consult the engine manual for this operation.