Release 00
2003-02
43
Scarabeo 50 I.E.-50/100 4T
CHANGING NUMBER PLATE LAMP BULB
Carefully read p. 38 (BULBS).
To replace:
♦
Unfasten and remove the screw (1).
♦
Extract the rubber bulb holder (2).
♦
Remove the bulb from its housing.
♦
Install a bulb of the same type in the correct manner,
following the above procedure in reverse order.
Do not pull on the wires to extract the bulb holder.
NOTE
When reassembling, make sure that the bulb
holder is properly inserted into its housing.
REMOVING THE NUMBER PLATE LAMP
Carefully read p. 38 (BULBS).
♦
To replace the number plate lamp, it is necessary to
remove the three screws (3).
♦
Disconnect the relevant electric connection.
CAUTION
DASHBOARD
CHANGING THE DASHBOARD BULBS
Carefully read p. 38 (BULBS).
NOTE
Before changing a bulb, check the fuses.
The dashboard contains:
– the warning light bulbs;
– the dashboard lighting bulbs.
To change the bulbs:
♦
Remove the front handlebar cover, see p. 26 (REMOV-
ING THE FRONT HANDLEBAR COVER).
WARNING LIGHT BULBS
NOTE
Extract the bulb sockets one by one, in such a
way as to avoid positioning them incorrectly during the
reassembly.
♦
Extract the appropriate bulb socket:
Extract the bulb and replace it with one of the same type.
DASHBOARD LIGHTING BULBS
NOTE
Extract the bulb sockets one by one, in such a
way as to avoid positioning them incorrectly during the
reassembly.
♦
Extract the bulb socket of the dashboard part in which
there has been a light decrease.
Extract the bulb and replace it with one of the same type.
(*) Some versions might not have this bulb.
miles
2
3
4
5
1
6
7
100
2
1
3
NUMBER PLATE LAMP BULB
100
Pos.
Warning light
Colour
1
Direction indicators (
)
green
2
Mixer oil reserve (
)
red
3
High beam (
)
blue
4
Injection check
red
Pos.
Lit part
5
Upper right part
6
Upper left part
(*)
7
Lower right part