Release 00
2003-02
24
Scarabeo 50 I.E.-50/100 4T
REMOVING THE FOOTBOARD
Carefully read p. 2 (GENERAL SAFETY RULES).
♦
Remove the inspection cover, see p. 22 (REMOVING
THE INSPECTION COVER).
♦
★
Unscrew and remove the four screws (3).
♦
Remove the four screws (4) from the bottom.
Proceed with care.
Do not damage the tabs and/or the slots in which
they fit.
♦
Slightly raise the rear part of the footboard and with-
draw it from the base of the inner shield.
Do not force the lower shield, since it is fixed to the
frame by means of two front screws only.
NOTE
Upon reassembly, first install the central tabs,
then next, the side tabs.
NOTE
Before installing the for screws (3), make sure
that the holes in the footboard and the screw seats are
aligned.
REMOVING THE LOWER SHIELD
Carefully read p. 2 (GENERAL SAFETY RULES).
♦
Place the vehicle on the center stand.
Before carrying out the following operations, let the
engine and the exhaust silencer cool down until they
reach room temperature, in order to avoid burns.
♦
After removing the footboard, remove the four screws
(5) on the bottom part of the vehicle.
Proceed with care.
Do not damage the tabs and/or the slots in which
they fit.
♦
Withdraw the lower shield (6) from behind.
♦
Remove the lower shield (6) completely.
NOTE
Upon reassembly, make sure that the front part
of the lower shield is correctly positioned.
CAUTION
CAUTION
WARNING
CAUTION
REMOVING THE REAR MUDGUARD
Carefully read p. 2 (GENERAL SAFETY RULES).
♦
Remove the rear part of the fairing, see p. 22 (RE-
MOVING THE REAR PART OF THE FAIRING).
♦
Disconnect the number plate lamp cables.
♦
Unscrew the 4 screws (1).
♦
Remove the mudguard (2).
NOTE
Take note of the positions of the number plate
lamp cables in order to replace them correctly during
reassembly.
2
1
3
5
4
5
4