SCARABEO 150
aprilia
aprilia
SCARABEO 150
DEALER INSTRUCTION SHEET
DEALER INSTRUCTION SHEET
Pag. 2
4
5
2
1
MAX
MIN
Pag. 3
SX
DX
2
1
2
FITTING THE CUP
M
Fit the cup (1).
M
Secure it with the 4 screws TBEI M5x25 (2).
FITTING THE MIRRORS
Fit the mirrors as follows.
M
Fit the mirror into its housing and secure with the
block nut, as shown.
M
Do the same for the righthand mirror.
The right nut has a slot, to show that it tightens
anti-clockwise.
CAUTION
Always connect up the battery breather hose to
ensure that sulfuric acid fumes do not corrode
electric plant, paintwork, rubber parts and gaskets.
CAUTION
BATTERY
Battery electrolyte is toxic, caustic and the contact
with the skin may cause serious burns, since it
contains sulfuric acid. Wear protective clothing, a
face shield and/or tight fitting goggles when
working around the battery. In case of contact with
the skin, flush immediately with plenty of water.
In case of contact with the eyes, flush with plenty
of water for at least 15 minutes. Immediately
consult an oculist.
If the electrolyte is accidentally swallowed, drink
large quantities of water or milk, and then milk of
magnesia or vegetable oil. Immediately consult a
health professional. The battery gives off noxious
and explosive gases; keep it away from cigarettes,
flames, sparks and any other source of heat.
During the recharging or the use, make sure hat
the room is properly ventilated and avoid inhaling
the gases released during the recharging.
KEEP AWAY FROM CHILDREN.
Do not tip the vehicle too much, or tip the battery
too much, to avoid electrolyte leaking out.
The battery liquid is corrosive. Do not pour or
sprinkle it, particularly on plastic parts. When the
battery has been removed it must be placed in a
safe place out of the reach of children. The battery
is very dangerous and may cause serious injury
or death.
INITIAL BATTERY CHARGING
M
Fill the battery with electrolyte to a level between the
“MIN” and “MAX” lines.
To top up the electrolyte use only distilled
water. Do not fill higher than the “MAX” level,
because the level rises during recharging.
M
Top up with distilled water.
M
Make sure the level is between “MIN” and “MAX”
printed on the side of the battery.
FITTING THE BATTERY
M
Make sure the ignition
key is in the “ “ position.
M
Place the battery into its housing.
M
First connect the positive cable (+) then the negative
(-).
M
Use a neutral grease or vaseline to grease terminals.
M
Connect the petrol breather hose (1).
M
Fit the battery support (2) using the screw (3) TCEI
M6x16.
M
Tighten the front hood (5) with the screws (4).
CAUTION
CAUTION
FITTING THE BATTERY AFTER FIRST
RECHARGE
Wait 5-10 minutes after recharging and then fit the
battery, since it continues to produce gas for a
period after recharging.
CAUTION