16
use and maintenance ETX 125
MAIN INDEPENDENT CONTROLS
CONTROLS ON THE LEFT SIDE OF THE HANDLEBAR
The electrical parts work only when the ignition
switch is in position "
n
".
1) HIGH BEAM SIGNALLING PUSH BUTTON
(
a
)
It makes it possible to use the high beam for signalling to
forthcoming vehicles while overtaking and in case of peril
and/or emergency.
2) COLD START LEVER (
e
)
The starter for the cold start of the engine is operated by
rotating the lever “
e
” anticlockwise
(Pos. A)
.
To disconnect the starter, return the lever “
e
” to its initial
position.
3) HEADLIGHT SWITCH (
o
-
p
-
•
)
Before operating the light switch, make sure that
the dimmer switch (
b
-
a
) (6) is in position “
b
”.
When the light switch is in position “
•
”, the lights are off.
When the switch is in position “
p
”, the parking lights and
the dashboard light are on.
When the switch is in position “
o
”, the parking lights, the
dashboard light and the low or high beam are on.
By means of the dimmer switch (
b
-
a
) (6) it is possible to
operate the low or high beam.
4) DIRECTION INDICATOR SWITCH (
c
)
To indicate the turn to the left, move the switch to the left; to
indicate the turn to the right, move the switch to the right.
To turn off the direction indicator, press the switch.
5) HORN PUSH BUTTON (
f
)
The horn is activated when the push button is pressed.
6) DIMMER SWITCH (
b
-
a
)
When the light switch (
o
-
p
-
•
) (3) is in position “
o
”, if the
dimmer switch is in position “
a
”, the high beam comes on,
while if it is in position “
b
”, the low beam comes on.
c
c
Summary of Contents for ETX 125
