Millie – Millie 30 – Freddie Installation
9-1-2022
APQS.com
42
Adjusting the Brake
1.
Insert a 3/16’’Allen wrench into the long bolt under the brake.
2.
Hold the screw steady with the Allen wrench.
3.
Lift the blue handle from its locked position, then rotate the
handle clockwise to tighten the brake or counterclockwise to
loosen the brake.
4.
Test the brake pressure by engaging the handle; repeat the
process if more pressure is needed. The handle is engaged
when its tip points down toward the brake.
Roller Brake Operation
Install the Pick-Up/Leveler Bar Brake
NOTE: If you purchased the optional Automatic Quilt Advance, you would not install a second roller brake.
Move ahead to the section titled “Install the Automatic Quilt Advance” on page 46.
Follow the same process to install the second brake to the Leveler Bar and Pick-Up Roller.
THE blue handle’s outward rounded (convex) side engages
the brake.
The blue handle can swing around 360 degrees; therefore, your
brake can be locked with the handle pointing toward the top
part of the brake OR the bottom part.
Install the curved
end of the brake to
the Pick-Up Roller.
