User's Manual
3.
OPERATION
3.1.
General
The ASRC is confgured and enabled/disabled through the "Clock" menu in a few
simple steps, described below.
The general sequence is:
1) Select the async input
2) Select the async output
3) Select the async clock (the clock source for async input+output)
4) Confgure the routing matrix (same as without ASRC)
You can always go back to the previous step by pushing the
Back
⮌
button.
See chapter "4. Confguration Examples" for typical setups.
3.2.
Select the async input
This selects the input interface whose data is received at its own asynchronous
clock and sample rate, and is then converted to the multiverter's main clock and
sample rate.
Push the
Set
button in the "Clock" menu.
Navigate the cursor to the
☼
ASRC
LED and push
OK
to confrm. The seven-
segment display shows
1n
to indicate the input selection mode.
You can now select the appropriate input row(s). The example shows how to
select "MADI optical" as asynchronous input:
Note:
For some confgurations it is possible to select two rows at once. This is
used if you want to concatenate the channels from two inputs to make use of all
8
