6
AT851 Battery Aging Tester
1.
Unpacking and Preparation
!
This chapter describes how to set up and start the AT851.
Incoming Inspection
Power Requirements
Setting up the Fuse
How to Remove the Handle
Environmental Requirements
Cleaning
1.1
Incoming Inspection
After you have received the instrument, carry out inspection during unpacking
according to the following procedures.
WARNING
If the external face of the instrument (such as the cover, front/rear panel, VFD screen,
power switch, and port connectors) appears damaged during transport, do not turn on the
power switch, in case that get an electrical shock.
Check whether the packing box or shock-absorbing material used packaging the
instrument has been damaged.
Referring to <Packing List> in the packing box, check whether all packaged items
supplied together with the meter have been provided as per the specified optioned.
1.2
Setting up Fuse
Figure 1-1
Fuse Holder
~Line: 110VAC/220V AC
20VA MAX
Fuse: 250V 1A
Slow Blow
Please use the following fuse type.
UL/CSA type, Slow-Blow, 5
×
20-mm miniature fuse, 1A,
250 V
To verify and replace the fuse, remove the power cable and pull out the fuse holder.
Two fuses in Fuse Holder.
1.3
Environmental Requirements
Set up the AT851 according to following environmental requirements.
