Applent Instruments AT381x, User Manual, Page: 72 / 134

AT381x User's Guide
72
Example
SEND> FUNC:IMP:AUTO ON
Query Syntax
FUNC:IMPedance:AUTO?
Query Response
{on,off}
Example SEND> FUNC:IMP:AUTO?
RET> off
10.7.3 FUNCtion:IMPedance:RANGe
The FUNCtion:IMPedance:RANGe command sets the impedance's measurement range.
Command Syntax
FUNC:IMPedance:RANGe <0-8,MIN,MAX>
Parameter Where, <0-8,MIN, MAX> is:
0-8, The range number
MIN, =Range 0
MAX, =Range 8
Example
SEND> FUNC:IMP:RANG 2 //Set measurement range to [2] 10k
Ω
Query Syntax
FUNC:IMPedance:RANGe?
Query Response
<0-8>
Example SEND> FUNC:IMP:RANG?
RET> 0
10.7.4 FUNCtion:DCR:RANGe
The FUNCtion:DCR:RANGe command sets the DCR's measurement range.
Command Syntax
FUNC:DCR:RANGe <0-8,MIN,MAX>
Parameter Where, <0-8,MIN, MAX> is:
0-8, The range number
MIN, =Range 0
MAX, =Range 8
Example
SEND> FUNC:DCR:RANG 2 //Set DCR range to [2] 10k
Ω
Query Syntax
FUNC:DCR:RANGe?
Query Response
<0-8>
Example SEND> FUNC:DCR:RANG?
RET> 0
10.7.5 FUNCtion:RANGe:AUTO
The FUNCtion:RANGe:AUTO command sets the auto range to ON or OFF.
Command Syntax
FUNC:RANGe:AUTO {off(hold),on(auto),NOMinal}
Parameter Where, {off(hold),on(auto),NOMinal} is:
off(or hold):
Sets the auto range to off.
on(or auto): Sets the auto range to on.
NOMinal: See Page
错误
!
未定义书签。
Section
错误
!
未找到引用源。 错误
!
未找到
引用源。
Example SEND> FUNC:RANG:AUTO AUTO //Sets to auto range.
SEND> FUNC:RANG:AUTO off //Sets auto range to off.
Query Syntax
FUNC:RANGe:AUTO?
Query Response
{HOLD,AUTO,NOM}
Example SEND> FUNC:RANG:AUTO?
RET> auto
10.7.6 FUNCtion:MONitor1 /2
The FUNCtion:MONitor1 and FUNCtion:MONitor2 commands set the two monitor parameter.
Command Syntax FUNC:MONitor1 {off, Z, D, Q, THR, THD, R, X, G, B, Y, ABS, PER VAC, IAC}
FUNC:MONitor2 {off, Z, D, Q, THR, THD, R, X, G, B, Y, ABS, PER VAC, IAC}
Parameter
Where, {off, Z, D, Q, THR, THD, R, X, G, B, Y, ABS, PER VAC, IAC}