AT381x User's Guide
34
Figure 4-6
Sweep Mode
4.4.2
Sweep [MODE] Setting
The <List Sweep> page completes the scan frequency or level value test of up to 10 list points.
When the test [Method] is set to sequence and [TRIG] is set to manual, the sweep function will
automatically execute each test step on the list in sequence until the last step. Users will wait
for the trigger button to be pressed.
When the test [MODE] is set to SEQ step and [TRIG] is set to MAN (manual), the sweep
function will automatically execute the first test step, then stop and wait for the trigger button
to execute the next step.
The instrument sweeps according to the trigger mode. The trigger mode usually uses manual
triggering.
Table 4-13
sweep method
Soft key
Function
SEQ
Trigger will scan all test points at a time.
STEP
Trigger only scans one test point at a time.
4.5
<ENLARGE DISPLAY> Page
The full screen display only shows primary and secondary parameters, monitor parameters,
and comparator results.
Figure 4-7
<ENALARG DISPLAY> Page