Applent Instruments Anbai AT8612, User Manual

Page: 66 / 77

66 AT8612 User's Guide
7.11.8 ATF:SET
ATF:SET command sets the data of automatic list file.
Command Syntax:
ATF:SET
<step>,<para>,<comp>, <level>,<width>,<high>,<low>
Parameter:
<step>,<para>,<comp>, <level>,<width>,<high>,<low>
step: integer, which step
para: alphabetic string, {cc|cv|cp|cr|short|open}
comp: alphabetic string, {i|v|p}
level: single-precision floating-point format, numerical value, unit according to
operating mode
（
A, V, W, Ω
）
width: single-precision floating-point format, pulse width, unit is "s", maximum is
25.5s
high: single-precision floating-point format, limitation upper limit
low: single-precision floating-point format, limitation lower limit
Example:
SEND > atf:set 0,cc, v, 1,2,4,3
//Setting up the first step as CC mode, numerical value
1A, delay 2s, compare voltage value V, voltage upper
limit 4V, lower limit 3V
Query Syntax:
atf:set? <step>
Parameter:
<step>
Step: integer, which step
Query Response:
<para>,<comp>, <level>,<width>,<high>,<low>
Example:
SEND
>
atf:set? 0
RET
>
cc,v,1.0000,2.0,4.0000,3.0000
Restriction: After finishing setup data, suggest to using ATF:SAVE command saving data.
7.11.9 ATF:FETCH
ATF:FETCH command retrieves each step's data.
Query Syntax:
atf:fetch <float>, <step>
Parameter:
<float>
float: floating-point number
step: integer
Query Response:
<float>
Example:
SEND > atf:fetch 0
RET > 1.000
7.12
BAT subsystem
Table 7-8 BAT subsystem tree
BAT :CURRENT {FLOAT}
:OFFVOLT {FLOAT}
:SECPARA {P,B,T}
BAT subsystem is used to set up battery measuring parameter.