Applent Instruments Anbai AT8612, User Manual

Page: 61 / 77

61
61 SCPI Command
7.9.6 TRAN:POWER:VALUEB
Setup method is the same as that of current.
7.9.7 TRAN:RESISTANCE:VALUEA
Setup method is the same as that of current.
7.9.8 TRAN:RESISTANCE:VALUEB
Setup method is the same as that of current.
7.9.9 TRAN:TRIG
TRAN:TRIG command sets the transient trigger mode.
Command Syntax:
TRAN:TRIG < cont, puls, trig >
Parameter:
< cont, puls, trig >
cont: continuous mode
puls: pulse mode
trig: trigger mode
Example:
SEND > tran:trig cont
Query Syntax:
tran:trig?
Query Response:
< cont, puls, trig >
Example:
SEND > tran:trig?
RET > cont
7.10
SEQ subsystem
Table 7-6 SEQ subsystem tree
SEQ :FILE {FILE0,FILE1…,FILE9}
:MODE {CC,CV,CP,CR}
:REPT {CONT,TRIG}
:COUNT {FLOAT}
:SAVE
:ERASE
:SET <STEP>,<LEVEL>,<WIDTH>
SEQ subsystem is used to set up sequence list parameter.
7.10.1 SEQ:FILE
SEQ:FILE command sets the sequence list file.
Command Syntax:
SEQ:FILE < file0, file1… , file9 >
Parameter:
< file0, file1… , file9 >
File0: Load SEQ listed file 0
File1: Load SEQ listed file 1
File2: Load SEQ listed file 2
File3: Load SEQ listed file 3