NOTE:
We recommend that this product is installed by the professional only. we accept no liability for damages caused
by incorrect assembly, installation or use. If there is any doubt, please contact the specialist from the seller for help.
Installing the Wall Mount
Also make sure that all of the hardware has been included with your mount.You should find the following:
Drywall Installation
Concrete/Brick Installation
Tools required for the installation:
• Phillips Head Screw Driver
• Electric or Portable Drill
IMPORTANT!
• For safety reasons, the wall or mounting surface must be capable of supporting the combined weight of the mount and
the display; otherwise the structure must be reinforced.
• Safety gear and proper tools must be used. Failure to do so can result in property damage and/or serious injury.
• Make sure that no electrical cables, water pipes or gas pipes are located within the wall.
1
2
1
2
Center of the stud
• 6 mm Drill Bit + Stud Finder ( Drywall Installation )
• 10 mm Masonry Bit ( Concrete Installation )
• Ratchet Driver with 1/2” (13 mm) Socket
Stud Finder
Tape Measure
Tape Measure
3
4
3
4
7
Fix the wall plate to the wall
using the Lag Bolt (A) provided.
Fix the wall plate to the wall
using the Lag Bolt (A) provided.
Insert one Concrete Anchor (B)
into each hole.
Use a pen to mark
off the locations
Make sure it is level
Use a pen to mark
off the locations
Make sure it is level
5
6
Choose the proper bolts for installation.
Install the screen on the display plate.
Hang the TV on the wall plate.
Pull the cord to lock the the bracket to the wall plate
(E) M4X20
(F) M6X20
(G) M5X20
(H) M8X30
(I) M6 washer
IMPORTANT SAFETY INSTRUCTIONS
CAUTION:
A CAUTION alerts you to the possibility of damage or
destruction of equipment if you do not follow the corresponding
instructions. Not following all instructions can result in serious
personal injury,damage to equipment, or voiding of factory
warranty! It is the installer’s responsibility to make sure all
components are properly assembled and installed using the
instructions provided.
WARNING:
Failure to provide adequate structural strength for
this component can result in serious personal injury or damage to
equipment! It is the installer’s responsibility to make sure the
structure to which this component is attached can support five
times the combined weight of all equipment. Reinforce the
structure as required before installing the component.
WARNING: Make sure that no electrical cables, water pipes or
gas pipes are located within the wall.
max
115
Kg
255lbs
max 800x500
7.6CM
(3.0")
