AFTER EACH USE
Very little maintenance is required on Apollo turbo spray systems due to the advanced engineering. The turbine motor has sealed bearings that
are lubricated for life. The only maintenance that you will need to perform is checking, cleaning, rotating and replacing your filters and pre-filters
as required. You should check your filters every 10 hours and replace as necessary. It is very important that your motor has cool, clean air to operate
efficiently. If you maintain your filters and prefilters well, you will enjoy many years of long service from your turbine motor.
In order to assist you in keeping accurate records of your maintenance and performing it according to the schedule we have built an hour meter
into the digital controls. Make note in the back of the instruction manual of the hours each time you clean, rotate or replace your filters and pre-
filters. If you write down the total number of hours each time you do your maintenance, you will have an accurate record of the last time you did it
and when it needs to be performed again.
NOTICE
-
Always use genuine Apollo filters and pre-filters. Other types of filters and pre-filters may prevent proper air flow to the motor,
resulting in premature motor failure and voiding your warranty.
PRE-FILTER MAINTENANCE
We recommend that you remove and clean your pre-filters after each use.
1.
To remove the pre-filters: push your finger between the filter and pre-filter until you can
curl it up and pull the pre-filter off, rotating your finger around the pre-filter as you pull. Do
not pull hard as you will break the glue line on the pre-filter. Make sure you check both
pre-filters as they can get dirty at different intervals. If they appear to be a little dirty or
clogged, you can wash them out using a mild soap and warm water. If they are not
cleanable you need to install new pre-filters.
To reinstall the pre-filters, hold one in both hands and apply the top first, moving your
fingers around the inside as you slide it back over the filter cartridge from top to bottom.
PRECISION-5 PRO LE TURBINE MAINTENANCE GUIDE
Always unplug your turbine from the main electrical supply before doing any maintenance or repairs.
1
A4098
Replacement Filters
A4096
Pre-Filters
For other Genuine Apollo replacement parts and
accessories please visit our web site and on-line catalog.
