IB(5”,4”)RUNNING BOARD
01-04 TOYOTA TACOMA DOUBLE CAB
Page 1 of 2
12/6/16 (DP) Rev 1
PARTS LIST:
Item QTY
Description
Item QTY
Description
#1
2 Running Board(use for left or right)
#10 12 10mm Lock Washers
#2
2 Front Upper Mounting Brackets (DFM/PFM)
#11 12 10mm Hex Nuts
#3
2 Rear Upper Mounting Brackets (DRM/PRM)
#12 8 8-1.25mm x 25mm Hex Head Bolts
#4
2 Driver Front/Passenger Rear Mounting Brackets (DFB/PRB) #13 16 8mm Flat Washers
#5
2 Driver Rear/Passenger Front Mounting Brackets (PFB/DRB) #14 8 8mm Lock Washers
#6
4 10-1.5mm x 25mm Hex Bolt
#15 8 8mm Hex Nuts
#7
8 10-1.5mm x 35mm Hex Bolt
#16 24 6mm T-Bolts
#8 16 10mm Large Flat Washers
#17 24 6mm Flat Washers
#9
8 10mm Flat Washers
#18 24 6mm Lock Nuts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY. ASSISTANCE IS RECOMMENDED.
2.
Starting on the driver side front of the vehicle, locate the (3) mounting holes in the body support.
Partially attach a front upper Mounting Bracket to the center mounting hole in the vehicle using (1)
10mm x 25mm Hex Bolt, (2) 10mm x 20mm OD x 2mm Large Flat Washers, (1) 10mm Lock Washer
and (1) 10mm Hex Nut. Use the included (2) 8mm x 25mm Hex Head Bolts, (2) 8mm Lock Washers, (4)
8mm Flat Washers and (2) 8mm Hex Nuts in the remaining inner and outer mounting holes. Snug but
do not tighten hardware at this time.
3.
Select a driver front lower bracket, attach to the front upper bracket with (2)10mmx35 Hex
bolts,(4)10mm flat washers,(2)10mm lock washers and (2)10mm Hex nuts
（
Figure 3
）
.
Snug but do
not tighten hardware at this time
NOTE:THE DRIVER FRONT LOWER BRACKET AND THE PASSENGER REAR LOWER BRACKET
ARE UNIVERSAL.
4.
Repeat
Step 2 &3
to install the rear driver’s side Mounting Brackets.
5.
Select a Running Board. Slip(12
）
6mm T-bolts into each bottom channel
(Figure 4)
. Carefully position
the Running Board onto the (2) Mounting Brackets.
IMPORTANT
: Do not slide, (front to back), the
Running Board on the Brackets or damage to the finish may result. Attach the Running Board to the
Mounting Brackets with(6) 6mm T-bolts,(6)6mm flat washers and (6)6mm lock nuts
(Figures 4)
. Do not
tighten at this time..
6.
Level and adjust Running Board properly and tighten all hardware.
7.
Repeat Steps 2-6 for installing passenger Running Board.
8.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
Driver Front/
Passenger rear
Mounting
Bracket
Rear Upper
Mounting
Bracket
Front Upper
Mounting Bracket
Driver Front/
Passenger rear
Mounting
Bracket
Driver rear
/Passenger
Front Mounting
Bracket
Driver rear
/Passenger
Front Mounting
Bracket
(2) Running Board
(example only)
