HALF FACE VISORS
APX-V20: APEX Clear Half Face Visor
APX-V21: APEX Smoke Mirror Half Face Visor
Protective eye shield for direct fit to APEX helmets. Low-impact protection,
designed for work at heights, outdoor work and industry.
WARNING!
Activities involving the use of this visor are inherently dangerous. You are responsible for
your own actions and decisions. Before using this helmet attached visor, you must:
• read and understand all instructions for use;
• only assemble the visor onto APX-02 and APX-05 Apex helmets
• get specific training in its proper use;
• become acquainted with its capabilities and limitations;
• understand and accept the risks involved.
Failure to comply to any of these warnings may result in eye damage, severe injury or death.
The manufacturer and/or distributor will accept no responsibility in the event of accidents
leading to injury or death due to improper use of the visor, or if the visor has been fitted
to other types of helmets. The APEX Visor is designed for maximum user comfort in an
industrial environment, and once damaged should be disposed of and replaced.
This helmet is designed as a protective eye shield from flying particles. Activities at height
and in industrial situations present a risk of serious eye and face injury. Wearing a visor can
significantly reduce this risk, but cannot entirely eliminate it. The APEX visor and helmet
assembly should be used exclusively for the activity for which it is certified
(see labelling).
• CE EN166:2001 () Optical class 2, Industrial eye protection visor
• Helmet- check the instruction manual for certification
ZERO ADVANCED HEIGHT SAFETY
•
•
zero4heightsafety.com
ZERO ADVANCED HEIGHT SAFETY
10 Holt Place,
Harewood,
Christchurch 8053,
New Zealand
Free Phone:
0800 357 003
P:
03 357 0093
E:
www.zero4heightsafety.com
This document in printed on an environmentally respon-
sible paper produced using Elemental Chlorine Free
pulp from responsible sources and manufactured under
the strict ISO14001 Environmental Management System.
SAFETY WARNING:
Helmets and visors must be replaced if damaged due
to severe impact, deformation or deterioration. Do not modify or remove parts. Replace the
entire visor if any damage can be seen, or if visibility is impaired by scratches or obscurity.
APEX Visor may be damaged by substances such as petrol, paint, adhesives, aerosol
sprays or cleaning agents. For correct use of the visor, mount only to the APEX Helmet as
instructed, and the Helmet should be worn with the retaining strap in place, failure to use
the chinstrap will lessen the designed protection of the helmet and the face visor.
