E-ITN 10
Installation and service manual
M2015/04b [EN]
5. O
THER
INFORMATIONS
5.1. A
LLOCATOR
PARAMETERS
SETTING
Basic settings as per Setting protocol is done by manufacturer. Parameters can be changed later with
Programming unit for changing allocator parameters of E-ITN 10.4, 10.5, 10.6, 10.7
connected to PC.
Settings or parameters adjustment can be performed only via built-in interface that is available only when
allocator is opened (disassembled from back plate).
5.2. T
RANSPORTATION
E-ITN 10 allocators can be transported under following conditions:
•
devices can be transported by all usual covered means of transport
•
devices must be in original package
•
originally packed devices must be stored and secured to avoid mechanical damages during
transportation
•
devices can not be transported together with aggressive substances
•
temperature during transportation from -10 °C to +55 °C
•
relative humidity from 45 % to 75 %
5.3. S
TORAGE
E-ITN 10 is an electrical device and can be stored under these conditions:
•
devices must be originally packed by manufacturer and individually stored in antistatic bags
•
storage temperature from +10 °C to +30 °C
•
relative humidity from 45 % to 75 %
•
devices must be stored in clean covered areas without aggressive substances and stored properly to
avoid mechanical damage
5.4. A
PPLICATION
AND
DISPOSAL
"This device is subject to a waste management in accordance with local legislation."
5.5. D
EFECTS
AND
THEIR
ELIMINATION
Any E-ITN 10 defect should be repaired by manufacturer only.
5.6. W
ARRANTY
If device E-ITN 10 is installed and handled according to manufacturer instructions mentioned in Installation
and service manual, manufacturer provide warranty under the valid legislation unless agreed differently.
The warranty is void if device was used contrary to Installation and service manual or damaged:
•
during transport or storage by customer or reseller
•
when mounted or dismantled to the customer device
•
because of improper handling or installation into other device than agreed in manual
•
if the product was exposed to different environment than agreed in manual
•
if mechanically or in other way damaged by user
15 / 39
