KVM-SET-14
APANTAC LLC, 10200 SW ALLEN BLVD STE C, BEAVERTON, OR 97005
, TEL: +1 503 968 3000, FAX: +1 503 389 7921
8
4.3 Network Configuration
The TX/RX provides the following Network settings:
IP Setup (TX/RX)
Enter TX/RX Web page [Network] ---> [IP Setup]:
Select Auto IP, DHCP, Static.
Then enter device IP, Subnet Mask, Default Gateway.
Click [Apply].
Casting Mode (TX)
(default Multicast)
TX can be set in Multicast or Unicast mode by entering TX
Web page [Network] ---> [Casting Mode]:
In Multicast mode, you can setup the following Multicast
address:
Multicast IP prefix (default 225.0.10)
Multicast IP address (prefixed with 225.0.10x.x)
Casting Mode Connection Methods (RX)
(default Multicast)
RX can be set in Multicast or Unicast mode by entering RX
Web page [Network] ---> [Casting Mode].
In Multicast mode, you can setup the Multicast IP prefix
and select the Connection Method from: First Available,
Multicast IP, OSD Transmitter List, and Direct Connection.
In Unicast mode, you can select the Connection Method
from First Available, OSD Transmitter List, TX IP and Direct
Connection.
First Available: the RX will connect to the first available TX when powered on.
Multicast IP 225.0.10x.xxx: the RX will connect to the TX with the same Multicast IP address.
OSD Transmitter List: the RX will display the available
Transmitters in OSD menu for user to select.
You can either select the “All Transmitters”, or using “-“ and
“,” for selecting TXs IP address range that are accessible for
this RX as the right screenshot.
TX IP: the RX will connect to this dedicated TX only.
Direct Connection: this setting enables RX to connect TX by
the same subnet, same Casting Mode, Jumbo Frame and
EDID Master will be automatically enabled.
Show TX Device name when connected (RX)
This feature enables RX to display the TX name (or IP) when connected. Default is enabled with
5 seconds.
Jumbo Frame (TX/RX)
The TX/RX Jumbo Frame must be enabled for the 4K input and output. (Default is Enabled)
Enter TX/RX Web page ---> [Network] ---> [Jumbo Frame] ---> Enable/Disable ---> [Apply] ---> the unit
will save the setting and reboot automatically.
Note: TX/RX and Ethernet Switch must have Jumbo Frame enabled (at least 8K) to work properly for
4K HDMI.
