AP Expert VT-110, User Manual

Page: 59 / 84

Chapter 14: Outputs
Setting the Clock Output Start and Stop Temperatures
1. Using the menu select arrow keys, navigate to Start / Stop Temps→Clock outputs .
2. Set the following parameters:
Clock mode The clock mode allows stopping a clock output at a certain time of the day or after a
certain run time. Select “Start/ Stop” to specify the time at which each cycle starts and
stops or select “Start/Run” to specify the running time of each cycle. Note that the
“Start/Run” option allows stopping cycles with more precision since this mode allows
adjusting the seconds.
On time / Off time
or Run time Set the time at which each cycle starts then set the moment at which each cycle ends.
Setting the 0-10V Outputs
1. Using the menu select arrow keys, navigate to Start / Stop Temps→0-10V Outputs , and then
select the desired 0-10V output.
This menu is accessible if a 0-10V output is enabled.
2. Set the following parameters:
Start temperature Set the start temperature to the desired value.
Minimum and maximum speeds
Set the minimum and maximum speeds of the 0-10V output. The
maximum speed must be greater than the minimum speed.
890-00081 Expert VT-110 59