- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
-11-
1. Connect the USB cable to a USB socket such as a mobile power supply.
2. Connect the controller with the USB cable. Solid green LED's indicate
charging status. Charging is completed when LED's are no longer on.
Note
:
Use an power supply with standard output voltage 5V and current
greater than or equal to 2A, otherwise there is a risk of overloading the USB
cable and Battery. A full charge takes approximately 45 mintutes.
Install TF Card
Controller Battery
Tips: Please turn off the controller before charging.
5V
As shown in the above figure, please push the camera module out and
insert the TF card
(
needs to be purchased separately )
into TF card slot. A
“click” signifies it is inserted correctly. Push the camera module into the
specified position of drone.
1. Please operate carefully to avoid damaging the camera module.
2. The original pixel-sized pictures and videos will be stored on the TF card.
TF
