Anywave MPTV, User Manual

Page: 58 / 96

MPTV V1 TX User Manual
MPTV-V1-1KW-USR-DOC-V1.0, 05/25/2018 Page 58 of 96
5.4 CONFIG SCREEN
Touching the Config button on theTitle Bar of the Home Screen, will navigate to
the Config Screen, as shown below. The Config Screen has seven functional
sections on the right. Press any of these buttons to navigate to that config screen.
The Network screen is used to configure all the TX networking parameters
including IP, Mask, and Gateway. The Time screen is used to set the current time.
The AGC screen is used to turn the Controller AGC On/Off and to change the target
AGC output power level. The AmpCf screen is for configuring the PA settings,
including FWD and REFL fault threshold settings, and power meter calibrations.
The Exciter screen provides Dual or Single Drive Exciter selection. The BootSet
screen establishes how many times the TX attempts to reboot itself on power loss
or fault conitions. The ClrALM screen allows the user to clear any previous alarms.
Please Note: Modifying factory default configurations of certain parameters may
lead to potenial damage of the transmitter.