Anywave MPTV, User Manual

Page: 50 / 96

MPTV V1 TX User Manual
MPTV-V1-1KW-USR-DOC-V1.0, 05/25/2018 Page 50 of 96
5. Local (Touch Screen) User Interface
5.1 HOME SCREEN
Turn on the power supply and the TX enters the initialization process, and after 5
seconds, the TX enters the home screen (as shown below).
The home screen is divided into 4 parts: Title Bar (left column), Power Metering
(upper right), Block Diagram (middle right) and Status Bar (lower right), as shown
below.

Title Bar : Shown in the picture above, the “Home” button is highlighted,
indicating the Home screen is now displayed. This TX Control Unit screen is
a touch screen. You may navigate to the other screens (Config, Log, Control,
Help) by simply touching the coresponding button in the Title Bar.

Power Metering

ON/OFF (Green) Button : Provides TX ON/OFF control. When GREEN
(as shown above), this indicates the TX is ON. When RED, this indicates
the TX is OFF.
Note: When there is an alarm, this button is always RED.

FWD: Forward Power Meter. Touching the white display box of FWD will
toggle its display units between “dBm” and “W”.

REFL: Reflected Power Meter. REJT” in the “Home” screen shows the
value of rejected power. Press the white box beside the “REJT” button, to
enter a screen showing all rejected power values. 1-PA TX has no reject
load. 2-PA TX has 1 reject load. 3-PA system has 2 reject loads. 4-PA TX