4
-Set to channel 20
on D bank
in FM.
-Press <<push-to-talk>> button on the microphone to transmit.
-At the moment, LCD would display SWR value which should be
as close as possible to 1. If this is not the case, re-adjust your
antenna to obtain a SWR value as close as possible to 1 (an
SWR reading between 1 and 1.8 is acceptable).
HOW TO USE YOUR RADIO
DW:
Appears when DW function is started.
10K:
Appears when +10KHZ function is started.
EMG:
Appears when EMG channel is used.
SWR:
Appears when SWR is used.
SRF:
Appears when S/RF is used.
SC:
Appears when SCAN is used.
TSQ:
Appears when CTCSS/DCS code is used.
NR:
Appears when RX noise reduction is turn on.
PA
、
CW
、
AM
、
FM
、
USB
、
LSB:
Indicate different operating modes.
1.
Appears when CLARIFIER function is FINE operation.
2.
Appears when CLARIFIER FUNCTION is COARSE operation or
RT operation.
3.
Appears when CLARIFIER FUNCTION is transmitting frequency
regulated.
<FRONT PANEL>
1.
OFF/ON/VOLUME(Inner Dual Concentric)
Turn clockwise to switch on
the radio
and set desired volume level.
Under normal operating state, the VOLUME control is used to adjust
the output volume obtained either by the transceiver speaker or the
external speaker or the external PA speaker, if used.
2.
SQUELCH (Outer Dual Concentric)
This control is used to cut off or eliminate receiver background noise in
the absence of an incoming signal. For maximum receiver sensitivity,
<LCD Display>
7 digits:
Display frequency and any other information.
Indicating bars:
Indicate RX, RSSI, PA, PWR, SWR.
The first decimal point:
Appears when current channel is edited with
SCAN DEL.
:
Appears after pressing FUNC key.
AQ:
Appears when ASQ function is started (only for AM/FM).
RB:
Appears when Roger beep function is started (enabled).
NB/ANL:
Appears when NB/ANL function is started (enabled).
BP:
Appears when BP function is started (enabled).
ECHO:
Appears when ECHO function is started (enabled).
VOX:
Appears when VOX function is started
.
NG:
Appears when TX noise gate is started
.
NC:
Appears when RX noise compander is started
.
HI-CUT:
Appears when HI
－
CUT function is started.
PUSH
MODE
BAND
TX
/
RX
CLARIFIER
PA
AM
CW
FM
USB
LSB
F
E
D
C
B
A
FUNC
RB.
NB
/
ANL
DW
SCAN
BP
+10KHZ
LOCK
SWR
LCDOFF
EMG
SC.LIST
HI-CUT
TOT
S
/
RF
OFF
OFF
RF
F
PWR
CHANNEL
RF
