Anybus Communicator - CANopen, User Manual

Page: 17 / 58

About the Module 12
Doc.Id. SCM-1200-121
Anybus Communicator CAN to CANopen
Doc.Rev. 1.00
2.4.2 USB Connector
At the bottom of the module you find a USB connector used for software upgrade
of the module and for uploading and downloading configurations.
Note : USB is used for configuration and software upgrade only and not for moni-
toring, modifying or exchanging data. Remove the USB cable when the configura-
tion of the module is finished.
2.4.3 CAN Connector
Next to the USB connector the CAN connector is found.
2.5 Power Connector
Notes:
• Use 60/75 or 75×C copper (CU) wire only.
• The terminal tightening torque must be between 5... 7 lbs-in (0.5... 0.8 Nm)
See also...
- “Power Supply” on page 42
Pin no. Description
1 +5 V input
2 USBDM (USB communication signals)
3 USBDP (USB communication signals)
4 Signal GND
Housing Cable Shield
Pin no. Description
2 CAN_L
5 Housing, CAN cable shield
7 CAN_H
1, 4, 8, 9
(not connected)
3, 6 CAN GND
Pin no. Description
1 +24V DC
2 GND
1 2
3
4
1 5
9 6
(male)
1 2