Anton Paar TTK 600, Reference Manual

Page: 40 / 85

6 Operating CCU 100
40 D52IB001EN-G
6.3.1 Navigation Diagram of CCU 100
The complete navigation diagram is shown below:
Fig. 47: Navigation diagram
The navigation diagram of CCU 100 contains three
different branches. The first, which contains the pro-
cess value, the set point and the error messages is
already described in the previous chapter.
By pressing the SELECT button it is possible to
switch between the branches of the navigation dia-
gram. Pressing the button once, gives access to the
parameter page.
Parameter Page
The following parameters can be found in the pa-
rameter page:
Changing of the values within the parameter page is
possible by using the UP or DOWN buttons.
Config Parameters
Pressing the SELECT button twice gives access to
the config mode of the instrument. Parameters that
can be changed in the config mode are described in
the following table.
Parameter Description Note
rAte Heating/Cool-
ing Rate value
[°C/min] Default value:
20 °C/min
cOn
cOFF Allows to switch
the cooling of
the instrument
on and off
Ln2
CAir
noC Toggle between
the CCU 100
configurations
for LN2 cooling,
compressed-air
cooling and no
cooling
CL Temperature
below which
cooling is per-
manently acti-
vated. Values
can be set
between 20 °C
and 50 °C. Default value:
24 °C
rot.S Sample holder
rotation activa-
tion;
values between
0 (no rotation)
and 10 (full
rotation speed)
can be adjusted Only for mea-
surements with
the capillary
sample holder
of TTK 600
OP shows the
actual heating
power of the
system in %.
Parameter Description Note
rAte: On
Off Allows to deac-
tivate the heat-
ing rate. This
results in max.
heating power
all the time. This parame-
ter is pass-
word
protected.
drAt Allows changing
of the default
heating/cooling
rate (20 °C/min)
from 1 - 300 °C This parame-
ter is pass-
word
protected.
Parameter Description Note