77
RSTP System Configuration interface
RSTP - Port Configuration
You can configure path cost and priority of every port.
1. Select the port in Port column.
1.
Path Cost:
The cost of the path to the other bridge from this transmitting bridge at
the specified port. Enter a number 1 through 200000000.
2.
Priority:
Decide which port should be blocked by priority in LAN. Enter a number 0
through 240. The value of priority must be the multiple of 16.
3.
P2P:
Some of the rapid state transactions that are possible within RSTP are
dependent upon whether the port concerned can only be connected to exactly one
other bridge (i.e. it is served by a point-to-point LAN segment), or can be connected
to two or more bridges (i.e. it is served by a shared medium LAN segment). This
function allows the P2P status of the link to be manipulated administratively. True is
P2P enabling. False is P2P disabling.
4.
Edge:
The port directly connected to end stations cannot create bridging loop in the
network. To configure the port as an edge port, set the port to “
True
” status.
